CHANGING THE BELT ON A KIRBY G3 G4 G5 GSIX ULTIMATE G

If this guide is helpful to you, PLEASE take a second and rate it (in the blue box below) to let me know how I'm doing. :0) Thank you!

I have the owners manual (both paper format AND on DVD) that you need at MY EBAY STORE ... (click on the link to visit)

My INSTRUCTION MANUALS are reasonably priced and will help you to get the most out of your Kirby. The manual would probably explain the belt change better, but here goes nuthin'... :0)

1)First, you turn the square belt lifter on the front of the power nozzle until the red arrows line up (belt off)

2)Remove the power head from the front of the machine. Now turn the belt lifter the other way and line the green arrows up again (belt on).

3)Turn it upside down and release the two clips that hold the metal baseplate on and remove the baseplate.

4)Grab the brushroll and pull it out of the power head. Slide the new belt onto the center of the brushroll. It will hang loose...it doesn't have to stretch around anything yet.

5)Look at the ends of the brushroll. The brushroll has three height settings...you should see notches AND NUMBERS on the sides of the brushroll's end caps. ONE notch (also #1) FACE UP on BOTH sides is the first setting and should be used when the roller is new. Three notches is the last setting used before a new roller is needed and should be used if the brushes are short and worn. Put the brushroll back in, making ABSOLUTELY SURE sure that the SAME NUMBER of notches and the same raised number on the edge are FACE UP on BOTH sides. This is important, as the brushroller will be unbalanced if inserted wrong.

6)Replace the baseplate by fitting the front clips into place and then push it down in back and secure it with the two rear swivel clips. Make sure it fits securely down over the bumper on all sides with no suction leakage.

7)Turn the belt lifter to where the RED arrows line up, making sure that the inner "hook" grabs the belt and stretches it up while you are turning it. Once you have the belt stretched up, put the power nozzle back onto the Kirby and lock it in place.

8)NOW...turn the belt lifter back to GREEN. If the little green light on the power nozzle lights up when you turn it on, CONGRATULATIONS!!! The brushroll is spinning!!

If this guide was helpful to you, please take a second and rate it (in the blue box below) to let me know how I'm doing. :0) Thank you!

Come visit my store for GREAT prices on Kirby supplies and parts!!

b0sslady2001

---

Orignal From: CHANGING THE BELT ON A KIRBY G3 G4 G5 GSIX ULTIMATE G